Learn Basics of Allen Bradley Micro Logix PLC in 1.5 Hours

Allen Bradley PLC programming in Micro Logix Software

What you'll learn
To understand how a Programmable Logic Controller (PLC) works
Pass a technical PLC interview
Understand how to program a PLC
Learn Ladder Logic Programming
Industrial Automation
Micro Logix programming interface

Requirements
Basic Electrical Hardware Understanding
PLC Software (Included in the Course)

Description
This is a comprehensive course for learning the basic level programing of Allen Bradley PLC in Micro Logix software. You will learn the logic designing of Micro Logix from scratch in a short period. No hardware equipment will be required to follow the course you will just have to install Micro Logix software on you PC and you can do it. Fundamental programming of Micro Logix will be covered step by step including the video lectures, assignments.

Couse Outline

1- Introduction of Relay Logic

2- Introduction to Allen Bradley Micro Logix

• PLC Block Diagram

• PLC Inputs and Outputs

• Working Principle of PLC

• PLC Communication Protocols

• PLC Wiring

• Sink/Source

• NPN & PNP Sensors

3- Basics of Micro Logix 500 Software and Communication with PLC

• PLC Specification

• Software Interface

• How to Create Tags

• Making First Program on Simulator

• Setting up Communication

• How to Monitor the Program Online

• How to Load Program in Simulator

• How to Build Ethernet Connection with PLC and Load Program

4- Basic Parameters

• Normally Open Contact

• Normally Close Contact

• Output Coil

• Series-AND Logic

• Parallel-OR Logic

• Parallel-NAND Logic

• Series-NOR Logic

• Assignment_1

5- General Internal Memories

6- Latching

• Latching with Output

• Latching using Latch and Unlatch Command

7- Timers

• On Delay Timer

• Enable of Timer

• Specifying the Duration of Time

• Resetting a Timer

• Off-Delay Timer

• Retentive On-Delay Timer

• Assignment_2

8- Counters

• Up Counter

• Resetting a Counter

• Down Counter

• Up-Down-Counters

• Assignment_3

9- Arithmetic Operations and MOVE Command

• Addition

• Subtraction

• Multiplication

• Division

• Moving Operands

• Moving Constants

10- Comparator operations

• Equal (=)

• Less Than (>)

• Greater Than (<)

• Designing of Complex Systems using Ladder Logic

11-Designing of Complex System Using Ladder Logic

• Assignment (Chemical Processing Unit)

Who this course is for
Anyone interested in learning how an industrial process works automatically
Electrical, Electronics, Mechatronics and Telecom Engineers
Production, Maintenance & Electrical Technicians